Enum libp2p_kad::BucketInserts

pub enum BucketInserts {
    OnConnected,
    Manual,
}

The configurable strategies for the insertion of peers and their addresses into the k-buckets of the Kademlia routing table.

Variants

OnConnected

Whenever a connection to a peer is established as a result of a dialing attempt and that peer is not yet in the routing table, it is inserted as long as there is a free slot in the corresponding k-bucket. If the k-bucket is full but still has a free pending slot, it may be inserted into the routing table at a later time if an unresponsive disconnected peer is evicted from the bucket.

Manual

New peers and addresses are only added to the routing table via explicit calls to Behaviour::add_address.

Note: Even though peers can only get into the routing table as a result of Behaviour::add_address, routing table entries are still updated as peers connect and disconnect (i.e. the order of the entries as well as the network addresses).

Trait Implementations

impl Clone for BucketInserts

fn clone(&self) -> BucketInserts

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for BucketInserts

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl PartialEq for BucketInserts

fn eq(&self, other: &BucketInserts) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for BucketInserts

impl Eq for BucketInserts

impl StructuralPartialEq for BucketInserts